GTN stuck on OBS page (resolved)

[LouP 116]

I picked up the Flysimware C402 today and on install elected to install to GTN 750s.  The install was only for the F1 750 but no problem, I used the RXP add on tool to swap them out for my RXP units.  However, for some reason when I enter navigation data into the first unit, it gets stuck on the OBS page.  Any ideas how to fix this?

Thanks,

LouP

PS.  I just noticed that when the unit starts up I get the message "OBS is not available due to dead reckoning or no active waypoint".  The other unit that is working OK (number 2) does not give this message

Edited October 1, 2019 by LouP
addition

[LouP 116]

Fixed this myself.  For some reason unit 2 was labeled the master in the .ini.  I switched it and made unit 1 the master and restarted the sime and all was well.

 

LouP