November 11, 20196 yr How can I calibrate 747 controls. I cannot make a complete flight, every time during takeoff / cruise A/P keep disconnecting. This is happening with all 737 series also. I tried work on P3D Calibration Device. I really have no idea what is happening. I have 12 years CH Yoke/Pedal, I like them. Please give me an advise Thanks Ahmet Sanal "Time you enjoyed wasting, was not wasted"
November 11, 20196 yr On FMC push MENU>PMDG SETUP>OPTIONS>SIMULATION>NEXT PAGE> under CTL INPUT WITH AP ON switch from ENABLE to DISABLE. I suspect that AP is disconnecting because you touch the yoke? With this setting this will not occur. Also in Calibration options try this please: Calibrate again your yoke and set Sensitivity for Aileron and Elevator axis @ 127 with NULL ZONE @ 1, Let us know. Regards Alex 747 Captain for the last 39 years, and still learning.
November 11, 20196 yr Author Alex, Thank you very much. "ENABLE to DISABLE" disabled and controls are working. Later on I will make my regular flight and will confirm you. I also changed to Sensitivity for Aileron and Elevator axis @ 127 with NULL ZONE @ 1," You saved my CH yoke / Pedal. I think they are thanking you,also. Edited November 11, 20196 yr by asanal Ahmet Sanal "Time you enjoyed wasting, was not wasted"
November 11, 20196 yr I'm very happy that I was able to help. Happy flying! 747 Captain for the last 39 years, and still learning.
Archived
This topic is now archived and is closed to further replies.