Hello, I'm not even sure if I'm supposed to post this issue on the forum. I have the Just Flight DC-10 HD for 64bit version installed in P3D v4.5. I recently purchased Ernie Alston's ISG set of gauges from Simmarket to use with the DC-10. There are no solid instructions on how to install the gauges into the aircraft. I've signed up for an account on their forum, but haven't been given administrator approval for my account to be active. I was going to post this on their forum. That was a week ago, and nothing. I know that Mr. Alston is busy with production at Quality Wings, but as a paying customer, I just wanted a bit of help to enjoy what I paid for.

I'm asking if anyone knows how to fully install the gauges into the DC-10. I've gotten the gauges installed on 1 variant in the 2d panel, yet the vc panel shows black holes where the gauges should be.

Thanks for any and all help! 

I have never tried installing the ISG into the VC.  I do run them as 2D popups.

I don't think I need to post my entire panel.cfg but here is a short bit of it:

[Window01]
Background_color=0,0,0 
size_mm=150,100
window_size_ratio=1.000 
position=3
visible=0 
ident=4007
window_size= 0.250, 0.450

gauge00=isg1!HW_MD11_ND,0,0,150,100