March 6, 20206 yr This is a very frustrating thing. I just purchased the Honeycomb yoke a few days ago. I am having flight control problems with all of my payware airplanes. Ailerons and elevator not working properly. I have spent countless hours of weeping and nashing of teeth trying to figure this out. I was assuming that the conflict was between Honeycomb, P3D, and or FSUIPC. Everytime I changed views from in the cockpit to outside the cockpit, the flight controls pretty much stopped working properly. For example, on the Carenado Phenom 300, when I would switch to the external view and look at the aircraft from the tail, the left aileron is up, right aileron down. When I move the aileron left, no alieron movement at all, but the left spoiler would extend, same thing when I go aileron right. However, I found after hours and hours of working through this problem, it appears that if I shutdown Chaseplane, then reopen it the problems "seem" to go away, and the flight controls work normally. Can someone please tell me if there is anything I can do to correct this problem? I'm still not totally convinced that this is the answer, but I'm pretty sure that there is a conflict somewhere between P3D and Chaseplane. Also, I would go ahead and fly. As long as I stayed in the cockpit for the most part the plane would fly normally. As soon as I went to an external view, the ailerons would cease working. Go back in the cockpit, for the most part, the flight controls started working again. Thanks for your help. A very frustrated flight simmer. Rodger Update: Problem still not solved. There is a conflict somewhere but I just can't figure it out. Now the flight controls only work from the external view. Going back inside the cockpit flight controls are inoperative. Edited March 6, 20206 yr by C130FE Update
Archived
This topic is now archived and is closed to further replies.