[Closed] "Exception 22"

[robert young 2,897]

Hi Simbol,

 

Sorry to trouble you again. I installed a great AI package from Orbx (for Australia/New Zealand AI). FSReborn has recognised all the aircraft in that package which I've separated into 2 groups: GA and Commercial. The "Scan and configure" command  loads these aircraft in the database perfectly with no errors reported. However when I go to preview mode all the other groups load aircraft and lights as normal, but when I click on either of the two new groups when in preview a scrolling message pops up in red fonts:  "Exception 22". The preview loads but there are no aircraft to be seen. If I click on the other groups everything loads ok.

Any suggestions please?

Edited June 5, 2020 by robert young

[simbol 5,832]

10 minutes ago, robert young said:

Any suggestions please?

Exception 22 means object not found. So via SimConnect AILRP is telling P3D to inject an AI Model and P3D is responding with an error indicating the SimObject doesn't exits, in other words, P3D doesn't recognize that object.

My best guess is one of the repaints or AI Model for that group is not being fully recognized by P3D. What happens when you run the content error report from P3D? this might reveal the AI Model / models with problems.

Regards,
Simbol

[robert young 2,897]

OK Thanks. I will investigate further.

 

Regards,

 

Rob