Linda 3.2.6 - Developer mode deactivates itself

[crisu19 0]

Hello,

I am using Linda 3.2.6. When I am selecting "Developer Mode" in "Setup Linda" the "Linda Tracer" and Linda Editor" activates.
But if I klick another Windows and then back to Linda, the "Developer Mode" deactivates automatically. Even "Linda Logging" setting in "Linda Console" behaves the same, setting is gone when leaving window.

The setting is stored in "linda-gui.ini", but when it automatically deactivated, this deactivation is synced to confilg file. I also tried to activate Dev-Mode via direct entry to config file, but it is immediately overwritten.

Linda did not behave like this in previous versions is used.
Is there a way to activate Dev-Mode and Log-Levels permanent?

Thanks and best regards,
Christian
 

 

Edited November 8, 2020 by crisu19

[ScotFlieger 280]

The logic has changed due to my need to get people to provide the necessary debug information. You need to activate Fault Diagnosis Mode (via Maintenance page ) to ensure Developer mode remains on.

[crisu19 0]

Great, thanks a lot for your quick reply.