ok, I may be getting some flak from this post but I gotta ask...is there a simple change to getting some planes from fs9 into fsx and then getting the jetways to move to the plane?At the moment planes I've imported cannot be emptied of people...I have planes on the tarmac which have been sitting there for days now, with very irate pax on board.....(chuckle)maybe this has been asked before, I'm not sure.....Chris

I don't know anything about it, however, a quick check of the aircraft.cfg of the default Boeing 737 and found a section called (in square brackets). Thomas[a href=http://www.flyingscool.com] http://www.flyingscool.com/images/Signature.jpg [/a]I like using VC's :-)N15802 KASH '73 Piper Cherokee Challenger 180

In FSX, the default aircraft have contact points in the exit section, all planes needs to have this in order to get the jetways/ground vehicles to work. Of course each plane will need editing in order to work correctly, it is do able, I myself have the POSKY 737 -600,-700 and -800, A330 -200,-300 A340-300, iFDG A319, A320, A321 all setup to work with default jetways.

Perhaps a bit more information would be useful. I assume those contact points you speak of are described in the section? (It's not clear from your note). And I also assume that there is no "model" related data necessary, IOW, that the only thing needed is a properly edited section?Thomas[a href=http://www.flyingscool.com] http://www.flyingscool.com/images/Signature.jpg [/a]I like using VC's :-)N15802 KASH '73 Piper Cherokee Challenger 180

Correct and correct.Hope this helps,--Tom GibsonCal Classic Propliner Page: http://www.calclassic.comFreeflight Design Shop: http://www.freeflightdesign.comDrop by! ___x_x_(")_x_x___