February 24, 20215 yr Hi guys. For my home cockpit, I use P3D on a I7 PC with a Geforce RTX 2080 ti graphics card. I use a HDMI splitter to split the image between my desktop monitor and an OPTOMA projector. I hadn’t updated my graphics card driver for quite some time until recently. I’ll describe what used to happen before and then after the update: BEFORE: I’ve always turned up the PC with the Optoma projector turned off. I would set up everything I needed to fly using the desktop monitor, and when everything was ready, I would turn on the projector. The image on the desktop would blink for 2 seconds and when it came back, it was much better, with very vivid colors, much better for flying in P3D. Then I’ve decided to update the driver to the latest version. Now, when I turn on the PC with the projector turned off, as soon as the Windows logo is displayed on the monitor, the image disappears and I get a “no video input” message on the monitor. When I turn on the PC with the projector already turned on, everything works ok, however the colors are very dull. One out of ten times, I get the nice colors that I used to get before the update, and upon investigating in NCP, I’ve found out that when I get the nice colors, the color display mode in the NCP is set to Accurate mode. When I get the dull colors, it is set to Enhanced mode. The thing is, when I start the PC and the mode is set to enhanced, I can’t find a way to switch it back to accurate. Even though I’ve been flying for many years, I’m no expert in video card tunings/specs, so I wonder if any of you guys could shed some light on what might be going on. thanks Eduardo Edited February 24, 20215 yr by DuduGuimaraes
Archived
This topic is now archived and is closed to further replies.