Hi all,

I have lived with the 10degree problem, expecting a fix from Asobo or Honey Comb, but I recently got the Just flight Arrow and with that I now also have to deal with all switches inoperable.

I gather that they can be remapped, but find the sim menu for this a bit.... well lets say its less than intuitive.

Does any one know of a guide for dummies to do this?

 

never mind .. much easy. was tired

Edited March 14, 20215 yr by Romeo_Tango
resolved the issue

2 hours ago, Romeo_Tango said:

Hi all,

I have lived with the 10degree problem, expecting a fix from Asobo or Honey Comb, but I recently got the Just flight Arrow and with that I now also have to deal with all switches inoperable.

I gather that they can be remapped, but find the sim menu for this a bit.... well lets say its less than intuitive.

Does any one know of a guide for dummies to do this?

 

never mind .. much easy. was tired

The 10 degree bug is supposedly being fixed in WU4 according to the development map.  If you don't want to wait any longer though, you can try this out.  I did it a couple weeks ago and it works well.  https://forums.flightsimulator.com/t/alpha-yoke-heading-and-flc-increments-of-10-bug-trim-sensitivity-solution/316380 

 

Word of warning, unplug controllers before installing VJoy and Joystick Gremlin.  One of those caused big problems when I tried to install with all controllers still connected (don't remember which one I think VJoy).  Install hung, then blew out the ability for the devices in Control Panel to be able to calibrate deadzones for some of my stuff. After fixing that and installing Vjoy etc again Windows reinstalled controllers as they were re-attached, but they all worked properly along with the new stuff to re-map the switches and avoid the bug.

Another option is to use Spad.Next for most of your bindings.  The only things I bind in MSFS are the pitch/roll and camera views because you can't do camera views via sim connect. using spad you are able to set the HC switches up so they press and release and do not spam the sim causing the bug. Also spad let's you do all kinds of things like conditional actions, drive panels, etc.

2 hours ago, sluflyer06 said:

Another option is to use Spad.Next for most of your bindings.  The only things I bind in MSFS are the pitch/roll and camera views because you can't do camera views via sim connect. using spad you are able to set the HC switches up so they press and release and do not spam the sim causing the bug. Also spad let's you do all kinds of things like conditional actions, drive panels, etc.

Do you have a spad profile correcting the bug? I have spad but have never been successful programming anything. I have used snippets and profiles in P3d. to achieve settings for my A2A  airplanes. 

Thanks every one. 

Edited March 14, 20215 yr by Romeo_Tango
resolved the issue

I just opened spad and foud what looks like profiles doing what I need. I havent checked for a profile there since a few days after the release of the sim. Im surprised to see there are as many profiles for MSFS there as there are Mods all over the internet.

6 hours ago, Romeo_Tango said:

Do you have a spad profile correcting the bug? I have spad but have never been successful programming anything. I have used snippets and profiles in P3d. to achieve settings for my A2A  airplanes. 

Thanks every one. 

Yes I can give you a profile for the bravo and or alpha if you want them. DM me if so.