Hi everybody,

for my first experiment with LINDA i'm using a BODNAR board BU0386X with the FSLabs module correctly installed

PIN 5 e 7 are reserved for ENG MODE SELECTOR with this configuration:

• PIN 5 on press: VC PED ENG MODE Start / on release VC PED ENG MODE Normal
• PIN 7 on press: VC PED ENG MODE Crank / on release VC PED ENG MODE Normal

When i move the switch in "start" simultaneously the flap levers move from pos 0 to pos 1 and if i repeat the action

the lever goes to 2 then 3 but not on FULL.......it's strange.

My first thing is that the Bodnar is not working well...but someone of you have an idea???

Thanks in advance

 

Max

 

I have checked out the LINDA FSL A3XX module 1.6 with the latest FSLabs A320-X v5.0.1.160 on P3Dv5.1. The Engine Mode functions are working as expected and there is no cross-coupling to flaps. I don't use a Leo Bodnar USB card but LINDA has been tested with them.

The first thing to check is that the outputs you are using behave like a joystick button push (eg. ON/OFF). This can be checked on the LINDA Joysticks page. On press the corresponding line should highlight.

I can see what you are trying to achieve with Pins 5 and 7. It is essential that these pins are not activated (On) at the same time (ie. 5 NAND 7) for your assignments to work.

 

Did you check if simulator arranged some strange button assignments by itself when you plugged the card in for the first time?

On 6/9/2021 at 9:21 PM, Ruler said:

Did you check if simulator arranged some strange button assignments by itself when you plugged the card in for the first time?

Hi all, sorry for the delay in replying, yes Ruler your suggest it's correct, it' was only a question of double assignments between the Bodnar and P3D.

Thanks again and forgive me for very newbee question.