In the World screen the info line (ends in Nav Log) shows only 2 of the 8 enroute waypoints which appear in the Nav Log below the info line.  The Nav Log shows all the enroute waypoints specified in the .pln file.  The World Map also shows all 8 way points.  

When the Flight Plan is loaded into the DA62 or C-172 G1000/Nxi display I seen only the 2 waypoints shown in the World screen Info line.  The same flight plan loaded into the TBM 930 G3000 shows all 8 waypoints. 

If I load the plan first into the G1000 (displays only 2 of 8 waypoints) and then use Developer Mode to switch planes to a G3000 I see ALL 8 waypoints.  If I load into the G3000 first and then change planes to the G1000 - the flight plan is empty.

This happens with many of the .pln flight plans I open/load.  

This is new behavior since the SU5 update. 

Are you using VFR flight plan? If yes, they added new automatic waypoints (which are highly undesirable) called TIMECLIMB, TIMECRUIZ and so on. They unfortunately cannot be removed and the autopilot insists on following them.

 

4 hours ago, Violins77 said:

Are you using VFR flight plan? If yes, they added new automatic waypoints (which are highly undesirable) called TIMECLIMB, TIMECRUIZ and so on. They unfortunately cannot be removed and the autopilot insists on following them.

No Low Level IFR and I do not see the TMECLIMB… etc.  I do see it in VFR