Apparently, this is the first AS365 post on the FXS forum. I feel like I'm in a vast minority of people that have purchased this helicopter for FXS.

I just installed the aircraft and find that the manual fuel control levers, their associated manual starter buttons and governor warning lights appear to be not modeled.

The strange thing is that I see youtube videos (probably made under P3D) where these elements are clickable and can be manipulated via the mouse.

When I pass my mouse over these levers, nothing happens, as if they are not modeled.

Has anyone else used this heli under FSX?

I have presented this question to Cera Sim support.... not yet answered....

Thank you

 

Edited August 31, 20214 yr by dontsink

Are you talking about these levers?

 

For more information you should be check User Guide of Cera AS365N3, already installed on your computer. ( Click Windows logo--- All programs--- Cera AS365N3 FSX SP2 folder )

 

P.d: I'm check in my FSX and found :

No1/No2  Manual stater and

No1/No2  Manual Fuel Flow Control Lever ( yellow levers )

It's modeled, you must to activate switches 14 and 15 ( switches below red cover tab ) before.

Yellow levers must be assigned to propeller axis for working.

Edited September 1, 20214 yr by polosim

Thank you. I did know what the levers and buttons were for. I did not realize that switches 14 and 15 actually allow the levers to be moved or not.

Does your statement about assigning to an axis mean that the levers are never mouse-selectable? What about the starter buttons?

The Cera Sim User Guide describes the names of the many switches but does not say anything about the functionality of the non-obvious ones.

I did find an actual flight manual on line today. Unfortunately, it too says nothing about manual vs automatic engine starting.

I was very happy to get a quick response to this question from Cera's Support people within hours of my submitting it. Thank you to Cera Sim.

 

6 minutes ago, dontsink said:

assigning to an axis mean that the levers are never mouse-selectable? What about the starter buttons?

1) It could be mouse-selectable but hardly to operate on that way.

2) Starter buttons works Ok with mouse buttons.

Hi Guys, i have install the cera as365, but if the engines are running, i have a lot of some comming out the helicopter. Some one else have the problem? Or a solution for it?