Hi.
I have two Saitek Switch Panels side by side.
Had them set up with AAO as aircraft midi devices ok.
I noticed the panels had suddenly stared to work with Saitek default assignments.
Checking the AAO Saitek Configuration setup I found that
there were four switch panels listed there with two of them set up for default assignments.
I set those two to aircraft midi as well and things are back to normal but there are still four panels listed in the config.
Any idea what's going on there.
This is with 2.20 and the previous version.

Thanks.

5 hours ago, gboz said:

Any idea what's going on there.

Not really. I would like to take a look into the startup log of AAO first, to see what hardware is actually being detected. Please send an email with your proof of purchase to the address on the last page of the manual.

 

Edited October 9, 20214 yr by Lorby_SI

OK, thanks.

On 10/10/2021 at 2:22 AM, Lorby_SI said:

Not really. I would like to take a look into the startup log of AAO first, to see what hardware is actually being detected. Please send an email with your proof of purchase to the address on the last page of the manual.

 

I'm getting this message when trying to send to your email as listed on page 18 of the manual:

"Sending of the message failed.
An error occurred while sending mail. The mail server responded:
relay not permitted, authentication required.
Please check the message recipient  ....... and try again."

Edited October 11, 20214 yr by gboz

10 hours ago, gboz said:

listed on page 18 of the manual:

No, I mean the AAO manual. Page 80+ = the very last page.

support at wildfiretrainingsolutions.com

Edited October 11, 20214 yr by Lorby_SI

12 hours ago, Lorby_SI said:

No, I mean the AAO manual. Page 80+ = the very last page.

support at wildfiretrainingsolutions.com

Ok, sent, thanks.