November 29, 20214 yr So I had posted this on the EZDok/EZCA forums but no response for a few days so thought I would try here as well. I have multiple controllers. My Yoko+ works fine. My Iris always worked fine. I also have an A320 Steering tiller. If I try to use that to pan as well (it is buttons not hat switch) it is like EZDOK is trying to lock the camera. It tries to pan but keeps shaking like it is trying to pan but stuck, Trying to pan the camera just shakes and can not actually move. If I disable EZDok then the buttons on the steering tiller can be used and work fine and panning has no issues what-so-ever. Re-enable EZDok and the view just shakes when I try to pan with the tiller buttons. It is like EZDok is trying to keep it locked straight ahead. Clearly it is a conflict between EZCA and the tiller for some reason. I have tried it with and without pan controls defined in P3D (Deleted in P3D controls directly) I haver tried it with and without the tiller as a panning device in EZDOK (using the configuration within EZDOK) I have tried enabling/disabling use as button in EZDOK joystick panning controls (Again within EZDOK) I do not have TIR enabled in P3D so that is disabled. Without EZDok both the yoko+ and the Cat Designs A-320 tiller work fine and I can pan with either device but as soon as I re-enable EZDOK I can no longer use the tiller to pan my view anymore. The Yoko+ is not impacted. Thank you, I can't figure out where the conflict lies with this one. I like using the tiller to pan as that way while I am taxiing I don't have to take my hand off the throttles or steering tiller to look around. Have a Wonderful Day -Paul Solk
November 29, 20214 yr If you go to the EzDok website, I believe there is an email link for a support ticket. That address is also in the docs that came with the software. Mark
November 30, 20214 yr Author 13 hours ago, newtie said: If you go to the EzDok website, I believe there is an email link for a support ticket. That address is also in the docs that came with the software. Mark Thanks Mark, I've spoken with Nick before was just hoping this was a quick fix and something I was overlooking that others could assist with. Weird that panning works fine until EZCA is enabled... Doesn't seem to be getting any answers on the EZDOK forums either so I will have to open a case. Have a Wonderful Day -Paul Solk
November 30, 20214 yr Author Wrong topic! Edited November 30, 20214 yr by psolk Have a Wonderful Day -Paul Solk
Archived
This topic is now archived and is closed to further replies.