Hello,

I recently replaced the toe brake pots in my CH rudder pedals but I neglected to take a picture before I disconnected the wiring. Now I just have the right brake pedal being recognized, but the left pedal and the rudder axis (Z axis) is not recognized at all. Is there a wiring diagram available anywhere so I can check to make sure I have all the wires connected correctly? I was unable to find anything on Google.

Hope this helps.

Per my CH Pro Pedal USB:

For Rudder : From left to right => Green = Ground,  Purple = Signal,  Blue = +5V  (view from the flat cap bottom facing up with tabs pointing down)

For Right Brake:  From left to right => Blue, Black, Green (view from the flat cap bottom facing up with tabs pointing down)

For Left Brake:  From left to right =>  Blue, Brown, Green (view from the flat cap bottom facing up with tabs pointing down)

Always double check all wires are connected properly before connect to USB port in PC to prevent damage to the CH controller.