Hi all

 

do the Beechcraft 18 ADF not working?

all bearing i try do not work.

Edited September 10, 20223 yr by Veteran66

It doesn't work for me..that's Carenado!

It seems that the main problem is tuning it.
Here is is working:

That's Carenado critics too quick to jump, here is a video.
I am on the ground at Sherburn in Elmet and the NDB there is 323 kHz

https://www.dropbox.com/s/81yxi33wwrpumwx/bandicam 2022-09-11 18-58-13-962.mp4?dl=0

I cannot get the tuning knob to set the 10s, so I have added a keyboard binding to do that. 

 

Edited September 11, 20223 yr by Reader

I understand the tuning by clicking the inner knob to go from 1 to 10  khz  but I couldn't get local NDBs to show.

Unless you tune the correct frequency, they will not show?
The gauge in the VC appears to only tune the digits and the hundreds and does not, apparently, allow for 0.5 of a kHz either.
As I mentioned, you can set the tens and the decimals using keyboard bindings.
The Sherburn NDB is 323.0kHz and of course, that number must be on the left side of the gauge to be active, as you
can see in the brief video and the screen shot.

I note that in the PMDG DC6, the similar gauge can tune all of the numbers, including the decimal.

 

Edited September 11, 20223 yr by Reader