Hi All,

I cannot edit/change de "Roll” value in a created event in the AxisAndOhs program.

 

The only way to change it is to create a template, edit the Roll value in the template and import this template again.

 

There should be an easier way I suppose.

 

Does anyone knows a solution ?

Ronald

Can't find anything wrong with the roll. I can change both boxes with the mouse wheel just fine. Can you be more specific about the issue?

34 minutes ago, RonaldvdStam said:

The only way to change it is to create a template, edit the Roll value in the template and import this template again.

This I don't understand at all. Are you talking about the XML files? If that is the case, you could edit the database file directly, it has the same format. "\AppData\Local\LORBY_SI\LorbyAxisAndOhs*\ConfigDatabase_*.xml"
But as I said, on my end both Roll boxes work as intended. Just be aware that you can only change/save the value when an event has already been assigned.

Edited October 9, 20223 yr by Lorby_SI

Ah, I see, with the mouse wheel it works, but only up until 9. A greater value still must be done by editing the xml file.

Is that correct ?

15 hours ago, RonaldvdStam said:

Ah, I see, with the mouse wheel it works, but only up until 9. A greater value still must be done by editing the xml file.

Is that correct ?

You are not supposed to enter a greater value - it will slow down the processing too much. Better to use a script instead.

Edited October 10, 20223 yr by Lorby_SI

Now I can use my Desktop Aviator Digital Trim Wheel. in FS2020 The Roll-Value 9 works just fine for this purpose.

Your software is a lifsaver 🙂

Thanks for the help.

Ronald