Hi! I use MSFS with a Midi Fight Controller's radial dials. Got A&O to work kind of and now I'd like to really figure it out but unsure where to go. Thanks for any info you can point me to.

1- How do I download updates?

I assign the throttle, mix, prop and elevator trim to a simulator axis and a couple of things occur that I do not know how to fix or tune.

2- When i load into a new flight, when I  first turn the radial dials the plane's controls will bounce to the zero position of the dial... like zero throttle, full lean, feather, and then the dial and the control will be synched after that. I think what I need is a setting to synch the control's position to the midi dial upon start?

3- how do I set sensitivity on the dials? For example the elevator trim can go from full up to full down in a very short radius making fine tuning almost impossible.

Thanks for the help!

1. Generally speaking, there are no updates, there only are new versions. When the release notice appears here in the forum, go to the shop where you bought the app, download  and install it. No need to remove the old one.

2. That is just how it is. There is no way to determine the state of a MIDI controller from the outside, it must send a message first. And it only does that when you move it.

3. That depends on the actual use case. Please post specifics (what device make and model is that, what axis has been assigned to which event and how, what are the Axis Min and Max values. what is the value range that is transmitted from the device etc.). In MSFS this is also potentialls different for every aircraft. There are no real standards with this sim.

Edited November 26, 20223 yr by Lorby_SI