Hi good afternoon I run the MSFS version of MCE I have done a couple of flight with the PMDG 737-700 and MCE with custom flows and checklist and works fine. But when I switch to the PMDG 737-800 the FO switches off and turns on all the wrong switches during the custom flows, the same flows I use for the 700 can't really figure out what is going on. Any help is appreciated thanks.  

7 hours ago, Jonny B said:

Hi good afternoon I run the MSFS version of MCE I have done a couple of flight with the PMDG 737-700 and MCE with custom flows and checklist and works fine. But when I switch to the PMDG 737-800 the FO switches off and turns on all the wrong switches during the custom flows, the same flows I use for the 700 can't really figure out what is going on. Any help is appreciated thanks.  

Very likely because you acquired the 800 AFTER MCE was installed.

PMDG planes are interfaced via their SDK and for FO to gain access to the switches and dials state, a specific option must be set in PmdgOptions.ini

These lines need to be present.

[SDK]

EnableDataBroadcast=1

In P3D or FSX, there is only one ini file for all variants. In MSFS, there is a separate file for each.

The MCE installer normally automatically edits those files for all expected variants provided the user has them at the time of the installation..

Solution:

Un-install MCE via Windows control panel.

Do not delete anything manually.

Download and install the very latest V3.0.3.2:

http://www.multicrewxp.com/Downloads.html