Need assistance with Carenado Pa44 Seminole

[jfwharton 50]

Today I was troubleshooting a sound issue with my aircraft in P3D 4.5 and before I found the actual issue I had decided to reinstall the Carenado Pa44 Seminole, which had no engine sounds.  After I reinstalled the aircraft i discovered what was actually causing the sound issue but then this new issue started.  Since I am running P3D v4.5 the Flight1 GTN does not work in that version.  I had switched over to the Reality XP GTN quite a few versions ago.  But now when I start the Pa44 and attempt to integrate the Reality XP GTN into the panel the bezel for the GTN doesn't show and the GTN comes up inside the GNS 530.  How can I fix this issue.  Is there a way to add a GTN bezel? or to configure the Pa44 Seminole to use the Reality XP GTN bezel.  I have tried the latter but it still comes up inside the GNT 530.  Any help would be greatly appreciated.  Thank you.

[jfwharton 50]

Another lesson from this is I need to backup the panel.cdg and realityxp.ini files for all of my aircraft because I can no longer install the Flight1 GTN and then have Reality XP replace them.  And since there is no F1 GTN to replace it would appear that attempting to replace a GNS 530 with a Reality XP GTN doesn't work.

[jfwharton 50]

Nevermind.  It's apparently been a while since installing a Carenado aircraft and I forgot I had to run the F1GTN750PA44.exe file.  Running that put in the bezel and then I was able to successfully set up the Reality XP GTN 750.  So problem solved. Just need to read the installation instructions.