Flyingiron P-38 Primer and Starter Switches

[Hollister56 0]

I was trying to bind the primer and start switches to my CH throttle quadrant switches, but can't seem to get them to work.

I can get default ones, like magnetos and landing lights switches to work but these two are tough to figure out.

Has anyone got these working?

Thanks,

Ed

Edited September 14, 2023 by Hollister56

[Hollister56 0]

I figured it out.  I had to put in the value to make it work.

Engine starter 1

0.0 Up or Left

1.0 Off

2.0 Down or Right

It's nice to use buttons instead of the mouse.

You have to go under the Scripting tab and read the LVARs,

They with show up under Local Simulator Variables.

Edited September 14, 2023 by Hollister56

[Lorby_SI 2,108]

I'm sorry, but I don't have that plane.

An alternative to reading the LVars is using the MSFS developer mode, Tools->Behaviors, then clicking back into the sim, hovering the mouse over the knob/lever/whatever and then press Ctrl&G. This will reveal the behavior code, and looking at the "ASOBO_GT_Interaction..." or "ASOBO_GT_MouseRect" components you should be able to find the proper BVar, LVar, HVar, K-Event or script code.