November 30, 20232 yr So, long story short, been trying this out for a few days. I have my settings configured as per the Fenix KB article here:https://kb.fenixsim.com/honeycomb-bravo-setup Now, that works perfectly with the FBW and Fenix throttles, but with the PMDG B737, I can't get it to "hold reverse thrust" and allow me to use the throttle levers to control reverse thrust as per the setup. So far I've just tried the 737, all the mappings are the same and while it is a different set of handles, it still presses buttons 10/11 when I pull the reverser handles, but moving the throttles forward seems to take it back out of reverse and applies normal power. Any thoughts? I'm using a mix of MSFS settings and some things set in SPAD, in this case all the throttles/axes are mapped inside MSFS, not SPAD (including those buttons), I use SPAD for the autopilot panel and buttons. Also if someone has a verified set of SPAD commands that allows the gear lever to come back to off... that would be welcome too lol. We spent 45 minutes yesterday trying to get that programmed in as well haha
Archived
This topic is now archived and is closed to further replies.