Increase the range above a FL

[cricorrea]

Hi Nico.

First of all, I would like to congratulate you on 10 years of PSXT. For those who really like total immersion, the app is essential. My mistake was starting to use it correctly recently lol...

I have a small doubt. Would it be possible to set parameters so that when passing through a certain FL, the range automatically increases to 100nm? Today I do this manually but it would be really cool if it were possible for this increase to be automatic. Today it only goes up to 40nm. Your reply will be highly appreciated. Thank you!

[kiek]

On 1/7/2025 at 2:12 AM, cricorrea said:

I have a small doubt. Would it be possible to set parameters so that when passing through a certain FL, the range automatically increases to 100nm? Today I do this manually but it would be really cool if it were possible for this increase to be automatic. Today it only goes up to 40nm. 

That would be possible indeed. I have experimneted with it in the past. A range of 100 nm is only beneficial for programs like Litlle Nav Map. Most TCAS systems in user aircraft do not go that far, do they? And in busy areas like London you would get a lot of traffic (and a drop in fps).

A FL parameter, default 40.000 ft, would be the best solution, so one can change it if one wishes.

 

 

Edited January 8 by kiek

[cricorrea]

Thank you for reply. Yes, I agree with you that it would be just for LNM or because of immersion. A parameter like this would be quite interesting. In high traffic areas like you are cruising, I typically haven't noticed a huge drop in my system.

[kiek]

See 10.1.0

[cricorrea]

Thank You Nico!! I will test later.