Hello everybody,Sorry if this has been answered befor, but all my searches could not give me the answer to the following question:What are the XML parameter to read out a helicopter's engine(N1, N2, Torque, EGT ...)?I tried to use the custom parameter for general, recip or turbine engine, but got only zeros or even no results.Is here any anything wrong with me, or is ther any trick I need to know?Any help really appreciated!Thanks in advance,Herbert

I would recommend trying http://www.hovercontrol.com , use the left side menu, at the bottom is the panel design forum.... get in there and ask "SKYMED" ... you WILL get your answer.If you do converse w/him tell him Roman say's howdy... :-)An opinion, You're relying on the R-22 .Air file ..... NON Turbine.If it spins on top, what works is what is found, and shared... Regards,Roman

Thank you for that link Roman.I'll try to get the answers there.I'm having probs with a turbine heli, so the gauges of the R-22dont help much.Never the less, thank you for your help.Herbert

>I would recommend trying http://www.hovercontrol.com , use>the left side menu, at the bottom is the panel design>forum.... get in there and ask "SKYMED" ... you WILL get your>answer.>>If you do converse w/him tell him Roman say's howdy... :-)>>An opinion,> >You're relying on the R-22 .Air file ..... NON Turbine.>>If it spins on top, what works is what is found, and shared...>> >Regards,>Roman>AND A BIG HOWDY TO YOU TOO !!!how goes it Roman, ltns :-)Steve