After doing a full install of RCV3 I do not get any chatter. How do I get it? Thanks

are you flying over water?

The same applies to me. I don't seem to get any chatter either??

what is your chatter slider set for?

It's set flat out - all on.Oddly today, I closed down RC3 and only then did I start to get RC3 chatter!!!!! Strangest thing.I was using the Cap Sim 727. For some reason with the CS727 it seems it is not possible to make entries (commands and replies) into an undocked window and when you dock the window it disapairs. It seems too that RC3 hangs with CS727. It was after that, that I experienced the 'post RC3 shutdown' RC3 chatter.Ta.

advdisp must be docked to your panelmake sure more than half of the advdisp window is on a panel.which makes me think, isn't the cs727 panel just one big gauge? that could be the problem.there is a thread here, my eatkins, which describes how to make a panel, that can be toggled on and off. this panel contains advdisp. this might be your solution.as far as troubleshooting goes, fire up fs2002 with a stock ms plane and panel, dock advdisp, and run rc. does everything work ok?if so, then we will tackle the cs727

Hi, thanks for the reply,Yes,RC usually works fine. It has only been with the CS727 that it trips up.Ta.