Did a flight out of CYYD (Charlottetown PEI) and was given QNH calls.I thought that was fixed in version b.Thanks, Adam

do you recall what center you were on?

try downloading the current v3.01 at www.jdtllc.com/v3/rcv301.zipi went to cyyd, which is vancouver center, listened to atis, and it was altimeterjd

Sorry jd, it was CYYG. I believe it's Moncton Center.Thanks, Adam

Oh and I downloaded 3.01 and it shows up under ProcessViewver as v.3b.I tried downloading it again but it was the same file. It's the one that won't open RC if it's not in the same folder as the original RC exe. Sorry, I'm a bit confused!Thanks, Adam

sitting on the ground at cyyg, listened to the weather. it says altimeter.in explorer, hover over the rcv3.exe in your rcv3 directory. what build number does it say?jd

Ok I have 2 .exes in my Rc folder. I have winME and checked the properties on each .exe:rcv3 says version 3.0.0.1689and rcv3b says 3.0.0.1687Is that what you are looking for?Thanks jd and sorry to bother you with this. I really don't mind QNH, it would just be nice to have altimeter because some of my add-on a/c only have altimeter reading. Makes it difficult as I don't have a conversion table and I have to keep checking alt-z to make sure I'm at the right alt.

download rcv301.zip from the url i gave in a previous post, and unzip the contents (rcv3.exe) into your rcv3 directory.if it doesn't say 3.0.0.17xx, then you aren't running v3.01jd

downloaded RC3 v3.01 from link providedCYYG, FSS reported altimeter as 29.89, all ok here.John

Ok I got it now jd. I have 3.0.0.1727 and I can launch RC so I will try a flight a bit later and look for the change. Thanks a lot for the help. Adam

Just completed an excellent flight from CYWG to CYYC and all calls were altimeter. Works just great!Thanks again, Adam