July 23, 200619 yr I have just installed V4.02 but have struck a problem which I cannot see previously mentioned in the forum. I start fs9 and then start Rcv4 and all goes well momentarily. Then it stops working and at the back of all the screens I find window saying "Run-Time Error '75' Radar Contact.fsuipc.rc4.code". Would appreciate some advice on this please. Thankyou in advance:(
July 23, 200619 yr Ignore this post. I reloaded rcv4, v4.01 and v4.02 again and it appears to have rectified the problem..hope so anyway!
July 25, 200619 yr Sorry, but despite deleting and reloading several times I have this problem every time just I get underway. I get through the Clearance bit and then comes the dreaded "ding" and there it is "RadarContact.fsuipc.rc4code". Advice please but I'll also do the same as yesterdays post from Bud on the same matter.
July 25, 200619 yr I also have had this problem with version 4.2, but it doesn't happen everytime. Strange. Never had it before the update. Brian S.
July 25, 200619 yr Commercial Member have you clicked .flt/.wx and specified the correct path to where the .flt/.wx files are stored?if that is oklaunch rcclick debug (before you load the .pln)load the .plnclick start rcfly the .pln, duplicate the problem, send the .log zipped to [email protected] JD Read my blog
July 25, 200619 yr "have you clicked .flt/.wx and specified the correct path to where the .flt/.wx files are stored?"JD,What should the correct path be on a standard installation? I cannot find that in the manual.Brian S.
July 25, 200619 yr Commercial Member by default it is in "my documentsflight simulator files"jd JD Read my blog
July 26, 200619 yr My path to flight simulator files has been set up slightly different by the IT man who recovered my system after crash. However, I have inserted this path in 4.02.... and it is being shown as the default path when Rcv4 is started.
Create an account or sign in to comment