jhbchristopher

Don I seemed to have caused you a few problems, sorry about that. One thing you might want to try is to unhook the triplehead and just go with one monitor to see if you still have the same problem. That would tell you if its a triplehead issue or not.Chris Roberts,

Hmm, Ryan you would be referring to the Read before flying PDF. Thanks it worked perfectly.And Dan, it still sounds like your having a problem so here are some screen shot instructions for you.When your in your cockpit hit the printscreen button. Minimize FSXGo to your start menu and accessories to open painthit cntrl v this will paste your screen shot into paintsave the image as a jpeg to your desktopcome back to the avsim forums and when you reply to your post in the bottom right corner there is an upload buttonbrowse to your desktop where the jpeg is stored and select itthen upload itthen click on the post where you would like your imagescroll back down to the bottom right corner and select the manage current attachments button and select your imageHope this helps and sorry to hijack your post, good luck...Chris Roberts

Maybe I can help as I seem to be having a similar problem. My virtual cockpit view is right behind the cockpit door, in 2d the front panel works fine but when I change views to left or right there is no cockpit just the outside view. Don I hope I'm not hijacking your post and apologise if this isn't the same problem your having, I did post a screen shot of the 3d cockpit. Also I reran the installer and chose repair. Any ideas.Chris Roberts,

I use MY Traffic, its been great. I did quite a bit of research and found that it was pretty frame rate friendly. The models are nice also, I have the traffic sliders set to around 60. No issues at all though its been grate. You might also want to look on the main avsim forum, there's quite a bit of info there.

No,The problems with viewing AI landing gear occur while I taxi, this only occurs in the PMDG 747 and LevelD 767, When flying the FSX default aircraft ai landing gear can be sen without any problem, I thought someone else in this forum might have had the same problem. Any Ideas?

Have pmdg 747 for a few months now. The only problem I'm having is that the AI traffics landing gear is not viewable until I get closer to the traffic. Ive tired default AI, Ultimate traffic and my traffic x. Having problem in both 2D and Virtual cockpit. In 2d the AI gear is viewable most of the time if looking out the sides windows but in straight ahead view I have to get very close to the AI to see the Gear. Performance is great, 12 - 18 Frame Rate as busy airports with traffic sliders at 80%, have the same problem of not seeing AI gear at not so busy airports with minimal traffic. All graphics settings are maxed out except water, no auto traffic, minimal ships and boats. Any help would be great and I thank you in advance.Nvidia 8800gt1650 x 1050 monitorVista 32DX10 Preview enabled (had problem in 9 also)4 gb ramIntel Core 2 Duo Processor E4500 (2MB L2 Cache,2.20GHz,800 FSB)

AlaisterI just bought the exact machine, only difference being I added 4gb of memory, a new 500w power supply and the new 8800gt card. I just got it up and going this weekend and am still trying to figure out settings and tweaks. Right now the FPS with the queen are pretty low, almost not acceptable, I'm thinking it has to do with the set up though as fps with default aircraft are not much higher. My email is jhbchristopher@sbcglobal.net if you have any questions.