thomas747400

Hi I just installed Linda for my MCP Combo (Ver 1) but since I have done this VRi Sim no longer recognises my CDU2 (even when I rescan for VRInsight devices). How can I fix this? As far as I know, Linda does not support the CDU2... is this correct? Regards Thomas

Hi guys,I have a problem with my PMDG MD11 as it shows a graphical error after almost every flight (see attached screenshot). Sometimes the whole fuselage is missing. I also noticed that framerates drop from 50+ to about 18 once I switch out of the 2d view and back again (the framrates go back up to 50+ once I resize the window (in window mode). I have the Highmemfix=1 installed as well as the UIAutomation Centre. I am running Win7 64bit on a Nividia GTX480 GPU and a i7 processor with 12GB RAM.Any help would be appreciatedThomas

Hi guys,Back when I was flying with fs9 using fsinn1.2 I could switch the aircraft transponder to mode C with fsinn switching to the selected mode automatically. With FSX and fsinn 1.3 I found that I have to select the aircraft to mode C and then select mode c in the fsinn control panal. Is that normal? Is there a way to link the FSX transponer mode to FSINN? Thomas

Hi,I found that when landing the MD11 (FSX) in the 2D cockpit that the runway disappears under the panel on final approach. Are there any views available that allow the runway to be visible until touch down? Many thanks Thomas

Hi all, I noticed that when switching from the MD11 cockpit view to an external view and then back into the cockpit view, the frame rates drop from 80fps to 16fps. I then switch from windows mode into fullscrean mode and back again and the frames are back up at around 80fps. I run windows7 64bit on a i7 3.2GHz PC with FSX Acc. Any help would be appreciatedThomas

All is working well after the reinstallThomas

Thanks for the feedbacks gents, I did set the AutoBrakes to RTO before takeoff. I will reinstall the md11 and I hope that this might fix the problemThomas

I checked and even disconnected the throttle but the same problem is still happening. I confirmed that no other axis is accidentally set to the throttle. The odd thing is that the speedbrakes deploy and stay deployed, only the autobreak is disconnecting... very oddThomas

I haven`t had a landing yet, i am following the Angle of Attack training video and I am stuck at the high speed abort session :( Thomas

Hi I have a problem with my autobreaks after aborting a takeoff. Once I pull back the throttles, the Auto Breaks will not deploy and then I get the ABS disarm alert. I de-selected all joystick break axis but the problem still occurs.Kind regardsThomas