dexter10000

As I said these are not my settings they are recommended by Saitek on their support page, all I can say again is they work for me. Roy Pike

Hi these settings worked for me and I took them from the Saitek website so please don't blame me if they don't work for you Setup in FSX The Rudder Pedals have three axes, one for the rudder and two foot pedal axes that are used for the toe brakes. There is also a rotary wheel in the centre that allows for the tension of the rudder movement to be increased and decreased.Due to the way in which Flight Sim detects the pedals, they need to be correctly configured before you can start getting the most out of them.Start by going opening FSX and going to Settings > Controls > Control Axes. Select the Rudder Pedals in Controller Type. Double click the Event Brake (left axis) and depress the left brake when the change assignment box appears. Left toe will appear in the window, and then click ok. Repeat the process for Brake (right axis) and the right pedal. Make sure that there is a tick in the Reverse box for both brake axes. Finally, double click Rudder Axis and perform the rudder movement, so that the Change Assignment window detects the rudder axis. These are the only three axes that should be set to the pedals, if there are any more in the list delete them using the Delete Joystick Assignment command.Now that the axes are set, go to the Calibration window. Select the Rudder Pedals and then select Advanced Controls. Make sure that the sensitivities for both brake axes are set to 75-80% and that the null zones are set to 0% for both. The rudder should be set to 50-75% sensitivity with a small null zone of about 5%.Before you load a flight, you will need to disable Auto Rudder. To do this, go to Settings > Realism and make sure that the Auto Rudder box does not have a tick inside it.Now you are good to go. Load up a flight, when the plane is stationary on the runway depress the pedal, then release it. You will see the brake announcement in the corner of your screen. If all is well the indicator will appear and then disappear when the brake is released. If the brakes stay on, go back to Settings > Controls > Control Axes, and remove the ticks from the reverse box for the brake pedals. Best Regards Roy Pike

I have a set of Saitek Pro Rudder pedals which were playing up exactley as described. Brakes jamming and general erratic behaviour. However after adjusting the settings of the pedals they are now working perfectley with the737 NGX. Roy Pike

Still down for me

Hi AllI'm new to the site, trying to get on the PMDG website this morning cannot connect, anyone else encountering problems?Thanks