Purplemonkey

OK so we've established that point 1. the aircraft is doing as it should do only if it occurs at low speed or in excess of mach .62 2. is a genuine problem with pmdg ngx and can be resolved by the sp1c update as and when it's released or by switching the yaw damper off.and by the way i'm not a pirate and have paid for the software... any moderator can email me to ask for a receiptThanks to those who have provided assistance on this thread... wish i could say the same about those pointlessly highlighting the rules but I suppose people like that are in alllllll walks of life zzzzZ

Leffe - These are genuine problems I am not a PMDG basher - what was the problem with my post whereby you want my full name and what difference would it make to have this information.ZachLW - 1. The 737 as far as I am aware does not auto-trim in manual flight - it's not an airbus 2. In SE config the 737 will not auto trim rudder it's not a 777 after allSekstifire - It's during manual flight and SE manual flightDavieaerosoft - 1. Even during manual flight? 2. Is there a link to this as being a known issue with NGX and Single Engine config manual flight?

Hi thereDURING MANUAL FLIGHT AND MANUAL SE FLIGHTHaving purchased PMDG's 737NGX I have a major complaint that I cannot seem to rectifyThe A/C is automatically trimming in pitch on random occasions normally when dealing with large speed changes.THe A/C is automatically trimming the rudder during single engine events. Autorudder rudder is disabled and all realism slidders are set to most realistic.PMDG what is going wrong?

Anyone?

Does the 737NGX have auto-rudder enabled in SE as I can fly single engine without putting in rudder inputs and it automatically centers the side slip indicator. AUTO RUDDER IS OFF IN FS

Please helpWhen single engine after an engine failure - once the yaw has been contained and aircraft is climbing away the beta target (side-slip indicator) will not settle it swings randomly from one side to the other without any change to the rudder pedal deflection.The wind is set to zero.Any suggestions on how to resolve this? I am using CH Pro PedalsMany thansk

Thanks Fred! Is there anything else in the Cfg file that needs amending for ngx to run properly?All the best

Thanks guys - yep I'm using a wide panel an asus 276q res is 1920x1080 I thinkMust commend you all of your speedy replies really good to see fsx community still alive and kicking!Will give you an update as soon as I've got back from work

Pmdg please helpWhen I load the 737ngx SP1 and choose 2d cockpit the viewing angle and zoom is completely wrong.It's automatically loading with maximum zoom in setting so all you can see on the ground from 2d cockpit is the runway.Please tell me what zoom and viewing angle pmdg designed the 737ngx to be used with so i can fly with the cockpit view as it was intended.Many thanks