davemb60

I found a thread in this section of the forum and they stated this: "On your LINDA folders there are two main folders: LINDA and LINDA-CFG. Enter LINDA->aircrafts->Fenix A320->ident.lua. Here change the contents to: «simfolder="FNX_320_CFM"»." This fixed the issue. The SPD HDG and ALT encoders on the MCP Combo SPD work and change vaule on the FENIX A320 in the sim, but do not change on the MCP Combo display. Only the ALT on both MCP Combo and FENIX A320 in the sim.

Hello, I installed the Beta Fenix A320 v0.3 into Linda. I started MSFS 2020, then FSUIPC. I load the Fenix A320 in MSFS 2020 wait a minute and start Linda. On the Linda display it shows *MSFS Default not the Fenix A320. I am unable to use the Linda Fenix A320 Module. Why is MSFS 2020 Setting the Fenix A320 with *MSFS Default"? Could you please help me to resolve this issue? I don't think I did anything incorrectly during the installation. Thank you Dave B

Hello, I tried to download this and it did not work. Does this download link exist anymore? Are others able to download? Regards, davemb60

I tried the mesh setting at 5m and that fixed the problem with the sudden drop on rwy 27 at KBOS. Thank you Amalishkin. (Can't wait for some KBOS airport scenery to come out, I think FlyTampa is working on a reboot for KBOS)

Hi Everyone, Thanks for the responses. I think I will try the mesh approach and crash detection. I tried different airports. Specifically KSFO from FSDT. Worked perfectly. I will try a few other stock P3D airports. Thanks, Dave

Hello, I have a question for the pros. During an ILS landing using my PMDG 737 at 100 feet above the touch down zone on the runway my plane suddenly drops onto the runway. Any clues as to why this is happening? Thank you, Dave