jschenk

No nothing installed of that kind. but.... I tried a repair install of P3D: No luck I tried a repair install of PMDG: No Luck I uninstalled PMDG, manually removed the folder PMDG from P3D and then reinstalled PMDG: OK ! Of course I lost some setting, skins etc for the aircraft, but at least it is working again ..... As an IT guy I hate so say that I don't know what was wrong, but sometimes the end result is more important Jacques

Hi Dave thanks for trying but no luck, same result with the startup state empty. As stated earlier I don't think there's anything wrong with the "NGX Default" state, because when I load it manually after init start, it is working fine. Just to be sure, I configured the startup to load the "cold and dark" state during startup, amd here again, it does not, it loads the same state "about to take off" with everything fully operational. Jacques

No I just startup P3D in the aircraft and airport selection screen, there I select the 737 and some airport and press OK

I did just that but it made no difference. By the way right after installation of P3D this problem did not exist, it was introduced later, however I can't remember what was installed, changed etc (if any) Jacques Schenk

Hi when I load the pmdg ngx 737-800 in P3D it loads in a status where it is about to take off. When init is completed auto throttle is engaged and the plane start rolling. MCP panel settings are not the default. However in PMDG setup i specified Default NGX as the startup panel state. If I immediately pause the game and go into the FMC setup menu and I load the NGX Default state from there, I do get the normal state (with auto throttle off etc) Press execute and it loads normally This is however the startup state in my FMC setup, so it should do this right from the start: I have also saved this "normal" state as user defined state "jacques" and specified this to be the startup state, but this doesn't work either, when loading the plane, it still comes in the "autostart to be engaged" mode. (but again manually loading this state after startup does work) It looks like the panel state is ok by itself (because when I manually load it it is ok) But it looks like this state is not the state loaded during startup, I have nu clue on what state is loaded during startup. What can I do to have P3D start with the "NGX default panel state" ??? Regards Jacques Schenk