Matteo Cordaro

Hi. Still no solution. I've tried this but nothing? Anything else that can be done?

On 3/26/2019 at 6:51 PM, simbol said:

If you go to %APPDATA%\Lockheed Martin\Prepar3D v4\Prepar3D.cfg, and open the p3d.cfg, you'll see two parameters under the [GRAPHICS] heading:

MAX_POINT_LIGHTS.

And

MAX_SPOT_LIGHTS.

Default values are 250, increase it by 100 or 200 and retest.

Hi,

i've already posted on the FSLabs forum but no answer at all. I've got this problem: when i use the wing engine view nav light doesn't work. As soon as a move the camera back it works again. I use tomatoshade, the latest FSLabs A320 version and ChasePlane

Thanks in advance

Matteo

Thx guys i’ll follow your suggestions. 

I think thai i should upgrade my CPU in the near future

Hi guys, 

hope this question hasn't been already answered. I had some autogen problem with unlimited frame rate: it didn't load up. After locking my fps to 31 in P3D v4.4 the problem seems to be solved. However locking the fps to 31 my GPU doesn't work at full power and (40/55%) and i get bad FPS (15/25 FPS) Istead with unlimited FPS the GPU works arround 80/90% at all times with better fps (+10/15 FPS) bt autogen roblem comes out again. I have scenery draw distance set to medium and everythink set to High/Dense

System Specs

i7 6700k OC 4.5GHz

RTX 2070

16GB 2400hz RAM

Samsung C32HG70 144Hz 1ms 2560x1440 

I was wandering if it was possible to keep my GPU to 20/90% even with locked FPS

Thanks in advance

Matteo

Hi everyone

i've got a problem since v1.0.31 (non experimental). Chase Plane works perfectly since i start active sky for p3d v4.4 (latest built). At that time external view doesn't work anymore. Do you have any solution?

thanks in advance

Matteo

1 hour ago, hero93 said:

Had the same problem. There is a thread somewhere in the Lockheed forum. I had to set the autogen draw distance to medium to see autogen at the destination.  I hope they'll fix that,

I have the draw distance set to Very High. You mean  that i shold reduce it correct? 

Hi everyone. I still have the problem after following your suggestion. I've locked the FPS at 30 and dimmed the settings. Recently i've chacged my monitor to a Samsung C32HG70 (2K, 144Hz, 1ms). The problem is that after crusing during desent Autogen doesn't show up. Every time i have to relod the scenery and poin my viw down for minutes in order to make autogen loaded. I get quite decent FPS (20 to 30 in FSLabs) My settings are not maxed out and are quite normal (High). 

Yes i do run with unlimited frame

1 hour ago, Mace said:

Do you run "unlimited" frame rate setting?

Thx for your replies guys. I have all driver updated. I will reduce my settings and see if it world.

Yes sir i did. And i re-run the installerò to repair the installation

Hi guys,

aafter changing my GPU i expierience some problem with the outogen. After desending while landing, it is blurry with no autogen objects (houses, trees). In order to solve it i have to point the view down and wait. I have ORBX GLOBAL, VECTOR, OPEN LC and some regions. It happens during day or night. Mu sistem specs are i7 6700K OC 4.5, EVGA RTX 2070 and 16GB of RAM. I've already tried deleting my P3d.cfg

Any solution? Thanks in advance

I also have this problem. Can someone help?