Search the Community
Showing results for tags 'P3Dv6'.
Found 4 results
-
And another patch for v6: The Prepar3D v6.0 Patch 5 (6.0.35) contains the following changes: Additional updates to lighting time of day exposure values. Additional effect and lighting updates to the included third-party aircraft. Increased virtual cockpit dynamic light intensities. Increased flashlight daytime brightness. PDK dynamic lights updated to use emissive interpolant. Resolve an issue where Autogen Config Editor would throw exceptions when loading files. Adjust flow so the view is no longer reset when opening the Camera Control UI. https://prepar3d.com/announcement/2023/09/132037/
-
I'm not sure if anyone else has had success using EZCA with P3Dv6 but it initially wasn't working for me. I hadn't used P3D (v5.3) in a few months and decided to fire it up and make sure EZCA was working there as it can be very fussy with Simconnect. Turns out it wasn't working for me in P3Dv5.3 either. I remembered that I saw updates for v3.2.0.4 on the News | ezdok-camera.com website and had it installed (along with the small patch on the same page) thinking I was going to update to P3Dv5.4. I downloaded 5.4 but didn't install it. So, tonight when it wasn't working in P3Dv5.3 I ran the old installer (EZCA V3.2.0.3.exe) but still no joy. I ran the config tool twice (once for the actual config tool and next the 'Advanced Users' and selected Simconnect 10.0.61259.0. Then I fired up P3Dv6 and EZCA connected to P3D. Note that when I switched to Simconnect 10.0.61259.0 when I went back into the config tool the 11.0.61259.0 entry at the bottom was still highlighted. Not sure why or if it means anything. I haven't tried importing cameras or saving them - just wanted to get this 'discovery' out for others with EZCA since Chaseplane seems to have given up on P3D. Now, back to testing... Randy
-
I have P2ATC working well on my Prepar3d Version 5 for a while and constantly been keeping it up to date with the betas. Last week, I installed P3d Version 6 and it seems to be the version I will work with (after I figure out how to integrate Orbx scenery) I have yet to fire up Pilot2ATC and get it working with Version 6. Is there anything I should do? I have placed Make Runways in the LM P3d V6 folder and run that. What next? Aussie
-
Will there be an update so that compatibility with P3Dv6 can be achieved?
