Hello, folks,
After almost a decade, I´m back fo FS community, this time using FSX and a new computer made specially for it:
i7-2600k OC to 5Ghz
16Gb RAM 2000mhz Corsair
2 SSD - Samsung Pro 256mb for system and a 500gb for FSX
1 Seagate 3Tb for adicional scenery
Asus Geforce GTX 780 CU-II
Corsair obsidian 950d
Corsair watercooler H100i
Corsair PSU - AX1200
Asus monitor 27 inches
Well, after installing everything, some scenery, FSgenesis, some Aerosoft, Ultimate Terrain, many third party airports, Tileproxy, I purchased many Megascenery Earth states scenery
Then, I notice in Megascenery Earth that I can´t use even a Learjet. I have to fly at a minimum speed in order to have sharp textures around the aircraft.
When I fly, better textures appear here and there, slowly, till all area is covered.
I made some tweaks on fsx.cfg in order to improve this, like raising Lod radius to 6.5 ( improved but when I fly above 80knots same thing )
I remember that with Tileproxy I could fly on every aircraft keeping sharp textures. After some days teaking FSX, I´m almost to give up from Megascenery Earth.
I can only get full sharp resolutions if I stop the aircraft, then, slowly, texture high resolution around the aircraft begins to improve to the maximum quality.
Fiber parameter is set to 0.70 already.
I increased Lod radius to 9.0 and even to 15 and this improved a lot, but I get Out of memory crashes. FSX is a thing that when it begins to get good it crashes...
Any hints how to solve this problem ?
Thanks in advance,
Dihelson Mendonça