Hi when I load the pmdg ngx 737-800 in P3D it loads in a status where it is about to take off.
When init is completed auto throttle is engaged and the plane start rolling.
MCP panel settings are not the default. However in PMDG setup i specified Default NGX as the startup panel state.
If I immediately pause the game and go into the FMC setup menu and I load the NGX Default state from there, I do get the normal state (with auto throttle off etc)
Press execute and it loads normally
This is however the startup state in my FMC setup, so it should do this right from the start:
I have also saved this "normal" state as user defined state "jacques" and specified this to be the startup state, but this doesn't work either, when loading the plane, it still comes in the "autostart to be engaged" mode. (but again manually loading this state after startup does work)
It looks like the panel state is ok by itself (because when I manually load it it is ok) But it looks like this state is not the state loaded during startup, I have nu clue on what state is loaded during startup.
What can I do to have P3D start with the "NGX default panel state" ???
Regards
Jacques Schenk