When the ADF needle first picks up the beacon, the bearing shown is anywhere from about 90 to 180 degrees off. After localizer capture and closing in om the beacon, the needle swings and shows the correct bearing. I haven't seen any other threads on this issue, and this is after the update. Any ideas or suggestions?Thanks, louross.

When did you download/install the update? There was a revised version of the update released with the same version number.See the topic "a minor revision" (or something like that) near the top of the list of topics.Good luck.

Please see this pinned topic to see if it applies to you:http://forums.avsim.net/dcboard.php?az=sho..._id=94375&page=Best,Vin ScimonePMDGwww.precisionmanuals.comhttp://www.precisionmanuals.com/images/forum/devteam.jpg

Yes , okay, I'd missed that point, sorry.Thanks,"wakemeatthemarker"louross.