737 800/900 VSpeeds

[Guest Yukio]

Hi, and thanks for your great 737 series.I noticed a strange thing using your 737 800/900 aircraft.I set up all preflight with route, weight, flaps config and i get the 3 VSpeeds by pressing the right buttons on the FMC.All is set properly but... When i start run for takeoff (with TO/GA as always) i reach V1 and VR... try to pull up the nose but the plane just doesn't takeoff! I have to wait about 4/5 more seconds from VR to let it get airborne... at almost the end of the runway.This happens with 737 800/900 only, no problem at all with 737NG.Am i the only one with this annoying problem? :(Thanks in advance.

[fozzy]

do you set the trim correctly?Luca

[Guest Yukio]

Yes, of course... :((sono italiano anch'io :) )

[SwervR1]

With both of these longer 737 you have to make sure your not over-rotating and tailstriking. Run a replay and check. Just a thought.

[Guest tmetzinger]

>With both of these longer 737 you have to make sure your not>over-rotating and tailstriking. Run a replay and check. Just a>thought.>>>Did you set the flaps?