The track ir must be in FPS mouseview. When you enable track ir make sure you have msf2002 & FPS mouseview checked. F8 toggles these two modes.Then while you are in the sim I believe f12 will enable Active camera. This config file is in fs2002 main folder. This can be edited.So, f8 enables track ir msfs2002 mode or toggles it to fps mouseview mode. Then hit f12 to activate acp. In the options menu of fs2002/active camera pro make sure you have internal pilot view checked. head latency set at 1.00 and turbulence at 0.40.Now you will notice in acp mode the mouse will not dissappear, and when you look to the extreme edges of the monitor the view will not be centered. Use the mouse to recenter. Mouse third button will move mouse around with out moving the view. Likewise in fs2002 mode the third button will move the view.I have read in a post from the creators of ACP that they possibly in the near future will try and enhance these two, for better compatibilty.Also, what type of system are you running ? I've been tweaking with settings so I can get the most out of 3d. Right now I run at 90% stereo with good results frames at 20fps. Make sure you have T&L turned off, this will nullify the floaty's in the scenery.Have A Good Day !!!! Rex

Hi Barry-I see you a Radar Contact beta tester. I have been having discussions on RC forum, because I cannot get Advdisplay and RCV3 to work in full screen in 3D. Too bad, that would be a great combo.