What are the default values for these two options presently i have them all set to 30% are these comfortable values?EDITAlso where do i get the B367 and MIPS have to be enabled each time new textures are installed right, especially after asv enhancement?

HI Joe,the vas frequency will depend on your preference.B367 is the (ASV Enhanced Upgrade from ASV), I think you already have this. Mips are enabled for the 128x128 by default, no need again to re enable mips.ThanksChris WillisHiFi Simulation Software Team Developerhttp://www.hifisim.com/images/asv_dev_team.jpg http://www.hifisim.com/images/asv_proud_supporter.jpg

Hi Joe,Wind Drift--zeroVAS--30 percentB367:http://sales.hifisim.com/pub-download/ASV_...ced_Upgrade.zipThat will not install any new clouds. The 128 cloud set is another download:http://sales.hifisim.com/pub-download/ASV-AE128.zipNot sure about the conversions. I'm sure Chris will be along!Edit: See, I told you he would be along!Hope this helps,JimActiveSky Sales and Supporthttp://www.hifisim.com/images/asv_dev_team.jpg http://www.hifisim.com/images/asv_proud_supporter.jpg

Thanks guys,Jim having wind drift on 30 is this an ok setting?EDIT:Chris when installing the enhancements because of new textures the mips are not installed on other sets unless by default Build 367 does it, previously B366 which is what i installed did not have mips enabled. It says in the mips and dxt section mentioning they were disabled.

Hi Joe,Sure, 30 seconds between small wind drifts is fine.Hope this helps,JimActiveSky Sales and Supporthttp://www.hifisim.com/images/asv_dev_team.jpg http://www.hifisim.com/images/asv_proud_supporter.jpg

Oh i get it its seconds not percent, ok thanks i'll keep it on 30 sec!Thanks!

Just curious are the dxt textures specifically the dxt3 format?

HI Joe,yes, dxt textures are dxt3 format.ThanksChris WillisHiFi Simulation Software Team Developerhttp://www.hifisim.com/images/asv_dev_team.jpg http://www.hifisim.com/images/asv_proud_supporter.jpg