I have recently started having problems with my ch products flight sim yoke. I'm sure many of you out there have this yoke. Now the problem i am having is with the button assignments. I am having aproblem with just one button located on the rightside where there is just 2 buttons that can be used up and down. the problem is that no matter what i set the button to it keeps controlling my landing gear. now i already have my landing gear set to a specific button and it works fine. as of right now i have the button set to diengage my auto pilot when i press it down now it does just that when i push it down it does disengage my auto pilot but it also lowers my landing gear. I have it set to turn the autothrottle on and off when i use the switch in the up position but then it also raises my landing gear. I have tried everything from uninstalling my pmdg plane and reinstalling it. but did nothing. i looked at all the key assignments and everything seems to be in order. Now i just dont understand it i never had a problem like that before. I also disconnected the flight sim yoke restarted my computer and plugged it back in but that did not work either. If anyone could help me resolve this problem i would greatly appreciated. i just want to start flying again its been over 2 months already and im going crazy. Thank you

In FS9, go to Options/Controls/AssignmentsUnder joystick type select CH Flight Sim Yoke USBSelect Buttons/KeysScroll down until you see landing gear. It will probably show a "g" under keyboard assignment. If it shows a joystick button assignment, delete it.If nothing shows under joystick button assignment, check FSUIPC to see if something is assigned there.If you are using the CH Control program, maybe someone else can offer a suggestion.Dale

There are at least 2 separate programs that could be setting the assignment.1. FS9 - Settings - Assignments - Joystick2. FSUIPC - Buttons (this one has got me a couple times!:))One of them has to be the culprit. Or another add-on that has a button assignment menus. Hope you find it! Bob...