Archived

This topic is now archived and is closed to further replies.

j14g

PDCR Display Blank

Recommended Posts

Hi Bob,I had to reinstall TM2. My previous install worked perfectly but now I can't get the PDCR to run. It's already set to STBY but the display is blank.I've reinstalled a couple of times but to no avail. I also tried going through the powered up C172 at KSEA, but still no display on the PDCS.I've double checked the Modules to make sure the correct .dll files were in place.Any idea what I could try next ? Thanks,Jack

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

A couple of possibilities:First, make sure you don't have a typo, duplicate gauge number etc in the panel.cfg file on the pdcs_cdu gauge line.Second, you need one of the main busses powered to run the PDCS. Make sure you have the electrical panel configured correctly, and that you have either APU or engine generator power connected.RegardsBob ScottColonel, USAF (ret)ATP IMEL Gulfstream II-III-IV-VColorado Springs, CO

Share this post


Link to post
Share on other sites