Archived

This topic is now archived and is closed to further replies.

BlueString

Traffic View Board Problem

Recommended Posts

Traffic View Board just freezes on the screen when I open it. It is only giving me like a screen shot of when I opened it. If I hold Shift+1 then there is a lot of little screen and they sorta make me view the ai plane. It is a little hard to explain. It is just Traffic View Board does follow the ai airplane, but when I click on it nothing happens, all I hear is the aircraft's engine but not on the screen. If anyone understands me could you please help?

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

Sounds as if you may have missed an important step during the installation.I would double check to see that the instructions were followed to the letter.All viewing of aircraft is setup on the TVB screen you see on your screen - the power has to be on, the scanning range has to be selected and the mode you wish to see (on the ground, departing etc) and the the follow aircraft option has to be selected.The use of Shift 1 should not be required.

Share this post


Link to post
Share on other sites

There is also a tutorial on it's use here in the library.tvb_tut.zip

Share this post


Link to post
Share on other sites