Ok let me first start to say that on the PMDG 737 for FS9 if I were lets say at LIRF at the gate I programmed my FMS including the SID departure on runway 34L I could decrease the range on my Display Unit and see were the runway are to taxi to .On arrivals if i programme a STAR it takes me right in , no problems here.I cannot seem to do this with the MD 11 , I get the SID programmed but it doesn`t show me were 34L is , I use charts to do this as I should but it is nice to see this on the DU.ThanksJohan

If the RNW is properly selected it should show up on the ND. Most likely problem is you must first select runway, then SID and last transition if any before *INSERT. Verify the selections on the FPLN page. I also use the runway as a reference for taxi but the ND is secondary, I always like having an airport diagram and I open a top down view window until I get to the runway.

If the RNW is properly selected it should show up on the ND. Most likely problem is you must first select runway, then SID and last transition if any before *INSERT. Verify the selections on the FPLN page. I also use the runway as a reference for taxi but the ND is secondary, I always like having an airport diagram and I open a top down view window until I get to the runway.

Thanks for this.Johan