Hi,i have been facing problems in md-11 ,upon loading the dark and cold panel,i get an initial message in my fmc showing sensor failure,and then the tat goes on increasing from an initial 14 C to 60 C,as a result of which i am not able to set a temperature for flex,this results in thrust problems with the engines not delivering enough power, i have uninstalled md-11 and face the same problems even after installing it again,i am not able to fly this aircraft at all,any suggestions would be welcomevivek

If you don't load a cold/dark panel does the same problem happen?A sensor failure usually points to the IRS, TAT indications are usually dependent on whatever the MSFS wx is providing to the aircraft so this indication is odd. No surprise that you have thrust problems at 60C. That is pretty warm.

Are you running FSInn for multiplayer by chance? I was having the same kind of issues with FSInn setting my TAT to all kinds of ridiculous temperatures.JamesAAL275

Well i was able to detect the fault in fsuipc, after resetting to default settings, it seems to have corrected the problem.thanks to all of you for the advisevivek