I would like to correct the taxiway lighting at one airport. The airport is KCDW created by Ray Lunning and John B. Loney, Jr.There are no taxiway lights showing during the day but they are lighted at night. I will probably use EZ Scenery to add all the taxiway lights so they will be visible both day and night but need to remove the existing night lights. Can this be done with AFCAD? Michael

I would like to correct the taxiway lighting at one airport. The airport is KCDW created by Ray Lunning and John B. Loney, Jr.There are no taxiway lights showing during the day but they are lighted at night. I will probably use EZ Scenery to add all the taxiway lights so they will be visible both day and night but need to remove the existing night lights. Can this be done with AFCAD? Michael

You should be able to adjust the inclusion (or not) of taxiway lighting using AFCAD.Try opening the airport in question in AFCAD and then Right Click on each taxiway link and select Properties. You will get a screen where you can select lights or not - left edge, center or right edge. There is no option to have them lighted at a specific time however.Hope that helps.

Thanks Opa. You never fail.Michael

Thanks Opa. You never fail.Michael

I forgot to tell you that if you hold down your CTRL key while you are highlighting taxi links and then Right click on any of the selected links, any edits you make to that one will be applied to all of the ones you have highlighted. Makes the job much quicker than doing each one individually.

I have a related question regarding taxiway lighting. I want to add red stop bars on the taxiways at the rwy holding points, I have seen these on many add-ons especially ISD. The stop bars change green as they are approached or crossed. How can i add these to some of my airports?Vololiberista

I have a related question regarding taxiway lighting. I want to add red stop bars on the taxiways at the rwy holding points, I have seen these on many add-ons especially ISD. The stop bars change green as they are approached or crossed. How can i add these to some of my airports?Vololiberista

I too have seen similar enhancements - especially at some payware airports.As far as I know these are not readily available for the average user but have been created especially by the authors of these airports.You might pose your question at the FSDevopers forum wher the "heavyweight" scenery designers hang out. Perhaps someone there could be of assistance.http://www.fsdeveloper.com/forum/index.phpHope that helps.