Recently a problem has developed with the Legacy 600 that I didn't have before. I've tried everything I know of to correct it. Maybe the AVSIM gurus have the answer.I am not able to get the thrust levers even in position nor in power settings when putting them into idle position. Number run only moves to 31% while #2 moves to 25%. I have two Saitek throttle units that worked the throttles perfectly before, assignments in FSUIPC along with calibration. I've tried reassigning levers and calibrating. I erased the profile in the FSUIPC.ini file and started over. I even downloaded the newest FSUIPC with the sync of the levers option and still no success. :( I'm not really sure when this occured, but I did use a program that was to correct the registry. I don't know if that could cause this issue or not, but the other levers assigned to the flaps and spoilers are not affected as they work just fine.I'm thinking of reinstalling the plane though I don't have, or can't locate the 'key' to activate it. I usually save those. I'll keep looking. :( Any suggestions?Thanks,Jim D.

old support forum -http://iemit.com/forumcan be searched, not open to new postscurrent support forum for feelthere developed aircraft -http://forum.iemit.comregistration requiredbelieve you can find your key in your wilco download space.make sure you have put the gustlock in the 'unlock' position.--

old support forum -http://iemit.com/forumcan be searched, not open to new postscurrent support forum for feelthere developed aircraft -http://forum.iemit.comregistration requiredThanks, I'll try there too.believe you can find your key in your wilco download space.make sure you have put the gustlock in the 'unlock' position.Was done, but same results--