February 1, 201016 yr Just installed v. 1.25 and 1.26 and wow, big improvement! The 'mouse just keeps getting better and better.Just one glitch though. I can't get the throttle trim to work unless I put the power up by means of the mouse on the throttle levers on the throttle quadrant pop-up. If I put the power up with my joystick throttle, when I click on + or - power either goes to idle or reverse. It must have something to do with my joystick throttle axis but I can't figure it out. Anyone have any ideas?
February 7, 201016 yr Usually this is an issue with how you set up FSUIPC for throttle mapping. In the FSUIPC joystick calibration tab page #1, do NOT check the "map to 4 throttles", and on page #3 check "Map 1 > 234 as req" if you're using a single joystick throttle axis to control both throttles.RegardsBob ScottColonel, USAF (ret)ATP IMEL Gulfstream II-III-IV-VColorado Springs, CO Bob Scott | President and CEO, AVSIM Inc ATP Gulfstream II-III-IV-V Sys1 (MSFS20+24/XPlane12+11): AMD 9800X3D, water 2x240mm, MSI MPG X670E Carbon, 64GB GSkill 6000/30, nVidia RTX4090FE Alienware AW3821DW 38" 21:9 GSync, 2x4TB Crucial T705 PCIe5 + 2x2TB Samsung 990 SSD, EVGA 1000P2 PSU, 12.9" iPad Pro Thrustmaster TCA Boeing Yoke, TCA Airbus Sidestick, Twin TCA Airbus Throttle quads, PFC Cirrus Pedals, Coolermaster HAF932 case Sys2 (P3Dv5/v4): i9-13900KS, water 2x360mm, ASUS Z790 Hero, 32GB GSkill 7800MHz CAS36, ASUS RTX4090 Samsung 55" JS8500 4K TV@60Hz, 3x 2TB WD SN850X 1x 4TB Crucial P3 M.2 NVME SSD, EVGA 1600T2 PSU Fiber link to Yamaha RX-V467 Home Theater Receiver, Polk/Klipsch 6" bookshelf speakers, Polk 12" subwoofer, 12.9" iPad Pro PFC yoke/throttle quad/pedals with custom Hall sensor retrofit, Thermaltake View 71 case, Stream Deck XL button box Sys3 (DCS/P3Dv4/ATS/ETS): AMD 7800X3D, MSI MPG X870E Carbon, Noctua NH-D15S, 64GB GSkill 6000/30, EVGA RTX3090 Alienware AW3420DW 34" 21:9 GSync, Corsair HX1000i PSU, 4TB Crucial T705 PCIe5 + 2TB Samsung 970Evo Plus, TM TCA Officer Pack, Saitek combat pedals, TM Warthog, TM RS300 FF wheel/pedals, Coolermaster HAF XB case
February 8, 201016 yr Author Thanks for your response Bob. You are correct, it's about throttle mapping. I haven't set up anything for any of my joystick axes in FSUIPC yet because I don't know how. I have the manual for FSUIPC but I don't understand what it's saying about axes yet.On page #3 the only throttles that are enabled for Map 1 > are #3 and #4. (map to 4 throttles on page # 1 is NOT checked). I guess I first have to set a single throttle axis to control throttles 1 and 2 but I can't figure out how to do that. Maybe I'll be able to figure it out from the manual eventually but it's going to take me a while.If anyone can explain to me very simply how to do this I would appreciate it very much. Would like to get the 'Mouse running properly so I can practice for my real-life 737-200 recurrent simulator coming up in April! I have to do an instrument rating renewal too.Regards,Tony PleasantsSenior Investigator Operations (Air)Transportation Safety Board of CanadaVancouver, BC
Create an account or sign in to comment