Hi guys,I've just recently got FS2Crew - MD-11. So as you do, I installed it and it works nicely. But this is where I don't understand, I use FSpassengers aswell.I start my flight, then go into FSpas and set that up .. pax, cargo, etc... and straight away I get a ZFWCG out of balance warning from FSUIPC. Can't seem to sort the problem out. I don't use the PMDG cargo/pax planner as I thought FSpassengers dealt with it all since it always worked fine with my PMDG 737.What you guys think?Tah very much,Stephen

Stephen,I recomend you use the PMDG load manager to load out the aircraft. We have a large number of users who report issues to support with the FS Passengers add on. It does not properly load out the aircraft and will cause exactly the type of behavior you describe.

Stephen,I recomend you use the PMDG load manager to load out the aircraft. We have a large number of users who report issues to support with the FS Passengers add on. It does not properly load out the aircraft and will cause exactly the type of behavior you describe.

Ok I will do. But can you tell me how I go about using FS passengers at the same time or is it just no possible? Another quick question is, if i decide to change the pax, cargo loads after landing during a turn-around, how do I do that without changing the aircraft?Thanks,Stephen

Stephen,Perhaps someone who has it can make recomendations. I personally don't use it and don't own it for the reasons listed.

Stephen,Perhaps someone who has it can make recomendations. I personally don't use it and don't own it for the reasons listed.

Ok thanks. I will probs end up just leaving FS pax.But one thing I don't know if there is an answer toit is, if i decide to change the pax, cargo loads after landing during a turn-around, how do I do that without changing the aircraft?Thanks again and sorry for being a pain.Tah very much,Stephen